this one haven't slept yet, going to catch a flight in a couple hours and made an all nighter to make sure you gonna have content while I'm on my way back to the kitties (already grown accustomed to fall asleep in the planes before they take-off), anyway...
"TheMostComfortableTanker" wrote a deep analysis of the armor changes and was very kind to authorize me to share with you on RSR:
Source.
France
105 leFH18B2
•More rounded at round parts, but otherwise the same.•The sides for the hull gun mount are now 60mm (+20mm).
•The driver's hatch no longer sticks out.
•Armor behind the tracks is now a very sloped section and a flat section, instead of a single slightly sloped section.
Verdict: Not enough to matter.
AMX 50 Foch (155)
•20mm sideskirts have disappeared.•Mantlet front buffed to 310mm from 250mm.
•Mantlet sides are slightly thinner, with the rear half being 60mm. A new weakspot, but probably would mean much.
•Indent on mantlet mount roof for the baby periscope is now 200mm thick where it would normally be a tiny flat 100mm weakspot.
•Flat front of mantlet mount is 200mm instead of 180, side of the mount are 170mm instead of 180mm.
•MG tumor shaped changed to more like a sphere. Front armor is mostly 175mm thick instead of 180mm-80mm, but the sides become 40mm much sooner.
•"Hammerhead" tumor is now armored just like the AMX AC mle 48, just with the the very base of it being 180mm instead of 130mm.
•LFP is now 62°, was 59°. UFP is now 55°, was 54°-56°.
•Spare tracks create a 50mm zone near the rear of the side hull (+10mm).
Verdict: I've not played this, but the mantlet area at least looks tougher from the front. Side skirts maybe helped against HEAT?
Germany
E-25
•Spare tracks create a 35mm area on side hull (+5mm).•Driver window no longer protrudes from the front plate.
•Top of mantlet mount is 20mm now (-30mm).
•Inside walls on the mantlet housing nerfed to 30mm (-20mm).
• Armor hole behind mantlet replaced by another piece of 60mm spaced armor.
•Mantlet shape changed and lost the 10mm spaced armor tube around the gun behind the mantlet.
•I hope people don't whine over what looks like a lot of nerfs in their head.
G.W. Tiger
•Hull MG weakspot removed.•Fighting compartment nerfed to 5mm (-11mm).
•Some changes to front hull slope. Nothing that changes anything.
Verdict: It's arty.
Nashorn
•Spare tracks create a 35mm zone on LFP (+5mm).•Driver hatch is now 10mm from all directions (-20mm front, -10mm side).
•Sloped rear floor plate same thickness as the rest of the floor (-5mm).
Verdict: Never had armor, and never will.
Pz.Kpfw. T-25
•UFP no longer has 45mm protruding hatches and MG mounts.•All MG ports and optics are as thick as their surrounding armor (buff).
•Hull side behind tracks is 50mm (+5mm).
•Spare tracks create 55mm zone on upper hull side (+10mm).
•Hull rear is 35mm (+15mm).
•Rear hull sloped plates can now autobounce 75mm ammo (+5mm).
•Hull and turret roof/floor are now both 20mm (+10mm).
•One cupola removed, the other shrunk and got thicker sides (+25mm).
•Armor hole behind mantlet taller, possibly slimmer too.
•No bumps on either side of the turret armor behind mantlet.
•Turret ring is 60mm and even smaller (+25mm).
•LFP is 45° instead of 53°, rear hull slope is 40° instead of 51°. Nothing else changed much.
Verdict: Mantlet might be a tiny bit worse and the tank taller, but the armor is certainly better.
VK 30.01 (H)
•Stock mantlet no longer is thinner near the edge.•Stock turret cupola is no longer stupidly tall (why was it tall in the first place).
•Stock turret has smaller armor hole behind mantlet.
•Spaced armor around rear side hull air intakes is gone, as is the 0 armor sliver
•New 60mm strip above UFP protecting turret ring
•Spaced armor in front of driver is 60mm but about half as tall (+30mm)
•Rear hull overhang is 50mm underneath (+30mm)
•No discs poking out of the hull at the front wheel (certainly harder to track+dmg)
•Top turret face no longer has 120mm zones.
•Top turret cupola is no longer stupidly tall (why was it tall in the first place).
•Top turret now has a 80mm turret ring, but not one too big.
•Top mantlet 40mm edges are now much smaller.
Verdict: Top turret face may be a bit weaker, but the cupola is now a whole lot less vulnerable, as it should be.
VK 72.01 (K)
•Like the E-25, mantlet shape is more like a cone and less like a tornado.•Armor hole behind mantlet at least appears smaller.
•A bit more flat front turret face at the edge of mantlet (nothing to aim at, but might get penned by some tier 10s on accident).
•Hatches on turret roof the same as the rest of the roof (+10mm).
•Turret ring roof area along the side and rear hull now has the turret fully over it (thanks, extra polygons!).
•200mm turret armor covers a bit more ground.
•120mm turret rear now covers a bit more ground too, but nothing to complain about.
•Cupola is no longer topped with a 70mm cone.
•Rear lower plate is 33° instead of 31°.
Verdict: Nothing huge. Mantlet area seems a bit worse, but there's also more bit area covered by 200mm instead of 160mm. Front hull is unchanged.
Japan
Chi-Ha
•Same changes as the Chinese one. Look at thatVerdict: Same armor as the Chinese one
Chi-Ni
•Slightly smaller armor hole behind mantlet•Armor from trench sled went bye bye
Verdict: It's the same
Chi-Nu
•Tracks no longer have an empty spot between them and the hull. Others have this too even though I never said it, but I've got to at least put something in hereVerdict: Even less changed than the Chi-Ni
Type 5 Ke-ho
•Lost those protrusions on the hull for the front wheel.•Tracks no longer have a gap between them and the hull
Verdict: I guess it's better
Great Britain
Crusader
•UFP nerfed to 20mm (-12mm), LFP nerfed to 20mm (-2mm), beak buffed to 32.7mm (+12.7mm).•Areas respectively angled 63°(was 65°), 28° (was 30°), 62° (was 64°).
•Driver's front is now 40mm (+8mm).
•Hull roof was 14mm, is now 9mm-4mm (and 12mm over driver).
•Bumps on engine deck excluded from hitbox
•Stock turret ring is 24.7mm all around (was 39mm frontal, 19mm side, 23.5mm rear).
•Minor tweaks to stock turret side and rear armor, new 14mm spot on turret rear.
•Small view port on stock turret no longer creates a bump
•Top turret sees similar side, rear, and turret ring changes
•Guessing the viewer is funny, but no more empty gaps in the tank where optics should go
Verdict: Armor was shit, now it's just a little more shit
Sexton II
•No gap between tracks and hullVerdict: Same thing as in 9.13
AT 15
•Frontal hull slope below gun changed (from 62° to 59° on the upper area, from 54° to 58° lower)•76mm mantlet weakspot around the gun removed (+51mm)
•Hole behind mantlet is a fair bit smaller
•127mm sloped bumps on either side of the gun look sloped better by a couple degrees at most
•Tumors and cupolas are the same thickness, shapes have just changed like they did on the AT 15A
• Part of side hull above tracks at the engine deck changed to 101.6mm (-50.8mm)
•Round stuff is more round. This tank has a lot of round stuff. Lower 228.6mm strip is rounded now instead of flat.
•Tracks are "hollow" now
•A few minor things you won't notice
Verdict: Mantlet is better for certain, other stuff is mostly minor buffs.
USA
M53/55
•Turret face is simplified (no mantlet, just flatness).•Cupola is a little shorter
•Spare tracks on turret face add small 19mm spots (+5mm)
•Front hull shape also slightly changed. Lots of minor changes.
Verdict: Still easily penned frontally by 75mm HE
T1 Heavy
•Sides of bump on stock turret roof are 63.5mm (+38.5mm).•Small 35mm box on stock turret roof removed.
•Stock turret bottom rear slopes are 63.5mm and 50.8mm (-19.5mm and -32.2mm).
•Front turret face is entirely 102mm, no more 82mm strip around the edges.
•UFP no longer has a bump for the MG housing or the thinner areas for MGs and vision slits.
•UFP slope increased from ~22° to ~30°.
•Sloped middle plate angle increased from ~60° to 60°-74°.
•Rounded front hull is 95.3mm-76.2mm instead of 102mm.
•70° plate from rounded area to hull floor is 44.5mm (-25.5mm).
•Rear hull is 46mm, with 25.4mm near the bottom (was 41mm).
•Roof no longer autopenned by 76mm guns.
•Top turret has changes similar to the stock turret.
•Top turret has no bump to uparmor, but there is a 82.6mm cupola now.
•Top turret has two new bumps near the edge on either side of the gun mount.
•Top turret gun mount sides now are as thick as the turret side, not front
•Tracks "hollowed out".
•Look at this picture for the side hull. Side hull was just a solid 44mm, shoulders 83mm.
Verdict: Everything changed, but should feel mostly the same. It's better in some places, worse in other
T20
•No bumps on side hull near suspension•Hull hatches no longer slightly thicker than roof (-6mm)
•Other hatches and view slits are no longer thinner
•Hull bump under gun is 76.2mm frontally and 63.5mm to the sides (+50.8mm, +38.1m)
•Hull MG front is 76.2mm and top is 44.5mm (+12.7mm, -19mm)
•UFP is now 46° instead of 48°, LFP 55° instead of 45°.
•Turret ring replaced with well sloped 63.5mm and 38.1mm armor
•Spare tracks on hull rear create 50.8mm zones (+12.7mm)
•Rear hull shape changed slightly
•Spaced armor around rear of turret ring changed to normal armor
•Tracks are a lot more hollow
•Stock and top turret mantlet shrank while the hole behind it grew
•Turret roof is harder to hit from the front, as well as other changes
•Top turret rear roof slope is 25.4mm (-38.1mm)
•Top turret front slope is closer to 30° now than 20°.
Verdict: Still a paper mache tank, but the LFP slope looks nice. Otherwise, lots of baby nerfs,
T28 Prototype
•You get a roof! It's 38.1mm thick.•You get cupolas too. Flat parts are 190.5mm, sloped is 152.4mm@50°.
•Bump on turret side to fit cupola is 165.1mm.
•Turret ring front is 203.2mm (+50.8mm).
•Turret sides near the front are 139.7mm (+12.7mm).
•Mantlet is now 203.2mm (+70.2mm).
•Hole behind mantlet is larger and less covered by the gun.
•Sloped things on front hull with tracks are 147mm (+20mm).
•Hull hatches removed.
•Hull MG weakspot no longer has little bump in the middle.
Verdict: Frontal turret side buffs are going to be really nice if the angles aren't different. I hated the tank too much to decide on the other stuff.
USSR
MS-1
•Hull armor is now 16mm from all sides (-2mm front)•Front hull slope is 8mm @70° now (-8mm, +1°)
•Hull no longer sticks out near wheels
•Tracks hollowed out more
•Front hull floor is 8mm (-8mm)
•Hull floor above tracks is 8mm (-8mm)
•Trench sled is gone
•Vision slits and other holes now as thick as the surrounding armor
•Bump on engine deck is now entirely 16mm (+8mm)
•New 8mm turret ring
•Stock turret rotated so the gun is no longer offest to the side
•Stock turret face with the MG on it is now 16mm (-2mm)
•Stock turret hole behind mantlet is larger
•Top turret armor behind mantlet is 8mm (-16mm)
•Top turret front armor is 16mm (-2mm, mantlet remains 18mm)
•Top turret armor on top and bottom of gun mount is 8mm (-8mm)
Verdict: Like the Crusader, this lost its front autobounce plate against most guns (still will bounce up to a 23mm autogun). Lack of a sled and more hollow tracks also make it slightly worse.
A-20
•Driver hatch removed•Spare tracks create decent sized 25mm area on UFP (+5mm)
•Stock turret has no armor hole for the gun and the weak spot by the gun is gone
•UFP is 55° instead of 56°, LFP 59° instead of 57°, beak is round instead of flat
•Hull bumps for rear wheel removed
Verdict: Still won't have fun against that KV-1
IS-6
•Turret slopes on front and side noticeable better.•Small 150mm spot on turret roof for a periscope removed.
•200mm strip added on turret below mantlet
•Mantlet is more sloped from the front
•Armor hole behind mantlet is so small now that the gun covers it. Mantlet on IS-6 is godmode now (150mm angled + 150mm flat)
•Driver hatch is 110mm now (+20mm)
•Driver optics area is no longer thinner on UFP (+20mm)
•120mm LFP overlap on UFP is noticeably larger
•Spare tracks on rear hull add a 80mm zone (+20mm).
•UFP angle changed from 64°-69° to 65°.
•LFP angle buffed from 51° to 53° and side hull from 44° to 46°.
•Rear hull slopes both descreased by a degree or two
•Lower edge of sloped side hull now slopes down at 43° with sideskirts over it.
•More of the sideskirt area is sloped
•Top of cupolas are rounded
Verdict: Russians thought the first HD model wasn't good enough, so they threw in a couple more buffs. Mantlet is now invincible too. Only nerf is that little area at the bottom of the UFP that was 69°, but is 65° now. That area has a bit more 120mm armor on it now at least.
No comments:
Post a Comment